Balford Blog

Zhejiang Balford Mechatronics Co., ltd focus on difficult stamping & deep drawing. Main product: motor housing and difficult custom deep drawn stampings.

In the process of automobile stamping parts, what is the material of small and medium-sized automobile stamping parts?

By : Categories : Blog,Industry Comment: Comments Off on In the process of automobile stamping parts, what is the material of small and medium-sized automobile stamping parts?

There are specific types of automotive stamping parts, including brackets, end caps, covers, oil seals, impellers, lugs, brackets, etc., all of which are stamped parts, because they are all stamped. In addition, according to its size, it can be divided into two categories: large impact and small impact.

In automobiles, for small stamping parts, materials such as SPHE, SPHC, ST12, and DC01 are generally used. DC01 and DC01 are the most commonly used. The ST12 has both. However, in this work, the following principles should be followed:

Principle 1: It should be able to meet the performance requirements of the parts and their use requirements. It can only be realized according to different usage requirements.

Principle 2: Stamping parts should have good process performance, good economic performance, and can be well processed by stamping and other processes.

In addition, in specific operations, the mechanical properties of excellent materials should be selected and determined according to the types of automotive stampings and their use characteristics. Because the material is different, its power is also different. Learning performance is also different. As long as the selection is correct, the product quality can be guaranteed and the purpose of saving can be achieved. A definite decision will then be made. Pick another suitable one.

It can be seen from this point that the selection of automobile stamping parts is very important, which will affect the use of automobile parts and so on. Because this work has to be done well. And to a certain extent, the correct and reasonable selection of automobile stamping parts is the basis and key to the subsequent use, and it must not be sloppy.

The above is the relevant content about the processing of automobile stamping parts. The processing principle of automobile stamping parts must be conducive to improving the utilization rate of metal materials, reducing the variety and specifications of materials, and minimizing the consumption of materials. Minimize wastage of parts while allowing the use of low-cost materials. I hope the above content will be helpful to readers.

About deep drawing

deep drawing, deep drawing parts, metal deep drawing, metal stamping, metal pressing, metal punching